No. Lubricating point Lubricant
1 Hood lock Paraffin wax
2 Hood hinges Oil
3 Sun-roof wind deflector Oil
4 Door lock outer sliding surfaces Paraffin wax
5 Striker plate Paraffin wax
6 Trunk lid hinges Oil
7 Door hinges (upper)
Door hinges + Door stops (lower)
Grease
Grease, oil
8 Front seat slide rails and latch devices Oil
9 Window regulator
Locking device (accessible after door upholstery panels removed)
Oil, grease
Silicon grease
10 Key holes Lock oil
11 Trunk lid lock Lock oil
pg. 59 Coolant
Check coolant level
The cooling system must be filled with coolant and not leak to operate at maximum efficiency. Check
the coolant level when filling fuel. The level should be between the "Max" and "Min" marks on the
expansion tank. The check should be made with particular thoroughness when the engine is new or the
cooling system has been drained.
Do not remove the filler cap other than for topping-up with coolant. Frequent removal may prevent
coolant circulation between the engine and the expansion tank during engine warming up and cooling.
Top up with coolant
Top up with coolant by filling the expansion tank when level is at the "Min" mark. Use a mixture of 50
file:///K|/ownersdocs/1977/1977_262_264_265/77262264265_03b.htm (5 of 14)12/22/2006 10:08:31 PM
To Next Page
Loading...
