4 When the primer surface is dry, the paint can be applied using a brush.
Mix the paint thoroughly, apply several thin paint coats and let flush after each application.
pg. 71 Paint touch-up
5 If there is a longer scratch, you may want to mask to protect surrounding paint.
Touching-up flaking fender edges and sills
Material:
Rust remover
Primer - spray
Surface finish - spray
Sand paper (H 150 - 300 grit)
Thinner
Note: When touching-up the car, it should be well cleaned and dry and have a temperature exceeding
+15° C (60° F).
Mask with tape and paper prior to painting larger surfaces. Remove the masking immediately after
application of the last paint coat, before the paint starts to dry.
Touching-up is as follows:
1 Remove the flakes.
2 Sand the damaged surface and wash it clean with thinner.
file:///K|/ownersdocs/1977/1977_262_264_265/77262264265_03c.htm (4 of 11)12/22/2006 10:08:32 PM
To Next Page
Loading...
