12
IMG-
379445
Take a sharp knife. First make a thin cut along the edges of the
inside of the template. This provides a groove to follow. Then cut
carefully out of the bumper cover.
Note!
Cut carefully. It is easy to slip with the knife and move outside
the template.
Remove the template.
Install the protective cover for the front engine block heater
socket from the kit. Check that it aligns. Adjust the hole using a
knife or file as necessary.
Smooth off the hole edges. Remove any swarf.
13
IMG-
231551
Fold the wing liner out of the way.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
To Next Page
Loading...
