Turn signals
1 Lane change position : In maneuvers such as lane changing, the driver can flash the turn signals by
moving the turn signal lever to the first stop and holding it there. The lever will return to the neutral
position when released.
2 Signal lever engaged for normal turns
3 High beam/low beam switch (headlights on)
Move the lever towards the steering wheel and release it.
Headlight flasher (headlights off)
Move the lever towards the steering wheel.
The headlight high beam will be on until the lever is released.
NOTE: Defective turn signal bulbs will cause turn signal indicator and remaining signal lights to flash
more rapidly than normal.
pg. 1:7 Windshield wipers/washers, Ignition switch
To Next Page
Loading...
