DRIVER SUPPORT
281
•
Reactivating Cruise Control from standby
mode (p. 283)
•
Deactivating Cruise Control (p. 284)
Activating and starting Cruise
Control
The cruise control function (CC
28
) must first be
selected and activated in order to be able to reg-
ulate the speed.
NOTE: The illustration is schematic - details may vary
depending on car model.
Set cruise control in standby mode
To set cruise control in standby mode:
–
Press ◀ (1) or ▶ (3) to browse to the sym-
bol/function
(4).
> The symbol is shown and the cruise con-
trol can then be activated.
Activating/starting cruise control
In order to start the Cruise control from the
standby mode, the car's current speed must be
30 km/h (20 mph) or higher. The lowest speed
that can be stored is 30 km/h (20 mph).
To start the cruise control:
–
With the symbol/function displayed,
press the steering wheel button
(2).
> Cruise Control starts and the current
speed becomes the stored speed.
NOTE
Cruise Control cannot be enabled at speeds
below 30 km/h (20 mph).
Related information
•
Cruise Control (p. 280)
28
Cruise Control
To Next Page
Loading...
