EasyManua.ls Logo

Volvo S90 TWIN ENGINE - Programming Homelink

Volvo S90 TWIN ENGINE
662 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
STARTING AND DRIVING
}}
* Option/accessory.
477
three programmable buttons and one indicator
lamp in the mirror glass.
For more information about HomeLink
®
, visit
www.HomeLink.com, www.youtube.com/
HomeLinkGentex or call the toll-free number
00 8000 466 354 65 (or the toll number
+49 6838 907 277)
10
.
Save the original remote controls for future pro-
gramming (e.g. when changing to another car or
for use in another vehicle). It is also recom-
mended that the programming for the buttons is
deleted when the car is sold.
Related information
Using HomeLink (p. 479)
Programming HomeLink
®
* (p. 477)
Type approval for HomeLink
®
* (p. 480)
Programming HomeLink
®
*
11
Follow these instructions to program
HomeLink
®
, reset all programming or reprogram
individual buttons.
NOTE
In certain vehicles the ignition must be
switched on or in "accessory position" before
HomeLink
®
can be programmed or used. If
possible, fit new batteries in the remote con-
trol that shall be replaced by HomeLink
®
for
faster programming and improved transmis-
sion of the radio signal. The HomeLink
®
but-
tons should be reset before programming.
WARNING
While programming HomeLink
®
, the garage
door or gate being programmed may activate.
For this reason, make sure that nobody is in
the vicinity of the door or gate while program-
ming is in progress. The car should be outside
the garage while a garage door opener is
being programmed.
1. Aim the remote control towards the
HomeLink
®
button to be programmed and
hold it approx. 2-8 cm (approx. 1-3 inches)
from the button. Do not obstruct the indicator
lamp on HomeLink
®
.
Note: The ability of some remote controls to
program HomeLink
®
is improved at a dis-
tance of approx. 15-20 cm (approx. 6-12
inches). Bear this in mind if you encounter
problems during programming.
2. Press and hold depressed both the button
on the remote control and the button to be
reprogrammed on HomeLink
®
.
8
Applies to certain markets.
9
HomeLink and the HomeLink house symbol are registered trademarks of Gentex Corporation.
10
Note that the toll-free number may not be available depending on operator.
11
Applies to certain markets.

Table of Contents

Other manuals for Volvo S90 TWIN ENGINE

Related product manuals