STARTING AND DRIVING
462
Fitting and removing the towing eye
Use the towing eye for towing. The towing eye is
screwed into a threaded socket behind a cover
on the right-hand side of the bumper, front or
rear.
NOTE
If the car is equipped with a towbar, there is
no rear mounting for a towing eye.
Fitting the towing eye
Take out the towing eye from the foam block
under the floor in the cargo area.
Front: Remove the cover - press on the
marking with a finger.
> The cover pivots around its centre line and
can then be removed.
Rear: Remove the cover – press on the
marking with a finger while you fold out the
opposite side/corner.
> The cover pivots around its centre line and
can then be removed.
To Next Page
