Volvo S90 - Page 583

MAINTENANCE AND SERVICE
}}
* Option/accessory.
581
Removing the plastic cover for bulb
replacement
The bulb in the halogen headlamp can be
replaced without the help of a workshop, but the
plastic cover over the headlamp must be
removed before a bulb can be replaced.
–
Press down the pins into the plastic cover's
four clips using a screwdriver or similar and
lift away the cover.
NOTE
Points to remember when the cover is refit-
ted:
•
The pin in the clip needs to be pressed
back fully before the clip is refitted in the
cover.
•
When the cover is refitted, the pin must
be pressed in until the end surface is
level with the surface of the clip.
Related information
•
Bulb replacement (p. 580)
•
Replacing the dipped beam bulb (p. 582)
•
Replacing the main beam lamp (p. 583)
•
Replacing daytime running light bulb/posi-
tion lamp bulb, front (p. 584)
•
Replacing the front direction indicator bulb
(p. 585)
•
Bulb specifications (p. 589)
Exterior lamp positions
The exterior lighting of the car uses a number of
different lamps. An LED
17
type lamp must be
replaced by a workshop. An authorised Volvo
workshop is recommended.
Lamps, front (car with halogen
headlamps)
Dipped beam
Main beam
Daytime running lights/position lamps
Indicator
Front fog lamps/cornering lights* (LED)
17
LED (Light Emmitting Diode)