||
SEATS AND STEERING WHEEL
* Option/accessory.
190
2. Make sure that the backrest with head
restraint does not come into contact with the
front seat when lowered. Lower the backrest
forward until it locks into position.
> The seat cushion folds down/forward
when the backrest is lowered in order to
create a flat surface. The head restraint
lowers automatically when the rear seat is
lowered.
WARNING
Make sure the backrests are properly locked
after they are lowered.
To raise the backrest to the upright position:
1. Pull the handle on the side of the seat
upwards and hold the handle in the raised
position while raising the backrest.
2. Make sure that the backrest with head
restraint does not come into contact with the
front seat when raised. Raise the backrest
and release the handle.
3. Push the backrest until the lock engages.
4. The head restraint is raised manually.
WARNING
Check that the backrests and head restraints
in the rear seat are locked properly after
being folded up.
The head restraints of the outer seats must
always be raised when there are passengers
on any of the rear seats.
WARNING
The head restraints on the outer seats in the
second seat row must always be raised when
the third seat row* is occupied by passengers.
Related information
•
Adjusting the head restraints in the second
seat row (p. 190)
•
Adjusting the seat longitudinally in the sec-
ond seat row* (p. 192)
•
Adjusting the backrest inclination in the sec-
ond seat row (p. 192)
•
Getting in/out of the third* seat row (p. 193)
•
Lowering backrests in the third seat row*
(p. 194)
Adjusting the head restraints in the
second seat row
Adjust the centre seat head restraint according
to the height of the passenger. Fold down the
outer seat head restraints* to improve rearward
visibility.
Adjusting the head restraint, centre
seat
The centre seat's head restraint must be
adjusted according to the passenger's height so
that, if possible, the whole of the back of the
head is covered. Slide it up manually as required.
To Next Page
Loading...
