CONNECTING WITH BT
1. Activate the BT-function on your device (Mobile phone, tablet etc.) from which you want to play the
music. See the operating instructions for that device.
2. Press the “MODE” button and activate BT-function.
3. Select “VONYX” on your BT-device and make the BT-connection.
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
REMOTE CONTROL
1. POWER ON/OFF
Press to turn the device on/off
2. MODE
Press to change modes
3. MUTE
Press to (un)mute the device
4. EQUALIZER
Press to change preset equalizer setting
5. VOLUME +
Press to increase the volume
6. PREVIOUS
Skip to the previous track
7. PLAY / PAUSE
Press to switch between play and pause
8. NEXT
Skip to the next track
9. VOLUME -
Press to decrease the volume
10. SCN
No function for this device
11. REPEAT
Press to switch between different repeat modes
12. NUM PAD
Direct number input
UHF WIRELESS MICROPHONE
Insert the batteries into the wireless microphone (observe the polarity) and turn all volume controls down. Switch the system to
‘ON’ and the power led will light. Switch the microphone to ‘ON’ and set the volume knobs to the desired position.
Take care not to incur feedback from the speaker. Turn the echo and equalizer to a position in order to have the desired sound.
CHARGING BATTERY
Prior to use this system the internal 12V battery needs to be charged for 12 hours. If the power switch is in the ‘OFF’-position
and the system is connected to the mains, the battery will be (re)charged and the charge LED will light.
Note: Pull the plug from the mains outlet as soon as the battery is fully charged.
The battery should be regularly charged. For optimal battery life, the battery should be charged at least once a month. Please
note that if you do not load within 6 weeks, the battery could become defective.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
UHF
No license required (excluding geographical restrictions)
Belgium (BE), Denmark (DK), France (F), Finland (FI), Germany (DE), Hungary (HU), Italy (IT), Netherlands (NL), Norway (NO),
Poland (PL), Portugal (PT), Romania (RO), Slovenia (SI), Spain (ES), Sweden (SE), Switzerland (CH), Great Britain (GB)
To Next Page
Loading...
Need help?
General
