OVERVIEW
1. Grille
2. Display
3. ON / OFF Switch
4. Frequency switch
5. Battery compartment 2x AA 1.5Volt
6. Battery compartment 1x18650 3.7Volt
7. ON / OFF Switch
8. USB Charge port
9. Charge indicator
10. Antenna
OPERATION
• Open the battery cover (6) of the microphone receiver and insert the supplied battery. Charge the battery of the
receiver using the supplied USB cable via USB charging port (9).
• Screw the battery cover of the microphone and insert 2x AA 1.5Volt batteries (5), note the polarity!
• Place the receiver in a 6.3 mm microphone jack for example, a mixer, active speaker, amplifier, etc.
• Switch on the receiver (7) and microphone (3).
• Synchronisation between microphone and receiver is automatic!
• If the channel is busy or interfering, you can change it manually by pressing selector switch (4).
To Next Page
Loading...
