Need help?Do you have a question about the Vorsprung Smashpot and is the answer not in the manual?
Overview of the three main stages and required tools/supplies for Smashpot installation.
Guidance to consult fork manufacturer service instructions for stock air spring removal.
Steps to disassemble and completely remove the stock air spring from the fork stanchion.
Overview of Smashpot components and isometric view for reference during configuration.
Guidance on selecting and stacking spacers to match desired fork travel.
Important safety notice regarding potential fork damage or failure from exceeding travel limits.
Additional installation steps required specifically for Fox 36 forks.
Torquing the foot nut and top cap, and adding the required suspension fluid.
How to use the adjuster dial to modify bottom-out compression damping.
Procedure for reconfiguring the shim stack to alter damping force.
Step-by-step guide to safely remove the existing coil spring from the fork.
Detailed process for installing a new coil spring using a shift cable for assistance.
To Next Page
General