19
If the heat boost for a heater is active, then the expired time of the heat
boost is stored and after deactivating the Stop & Go function, the remaining
heat boost time will expire (meaning the heat boost time does not continue
during the Stop & Go condition).
To deactivate the Stop & Go function, must be pressed for 1 sec. It is
acknowledged acoustically with a beep.
Afterwards release and actuate any button within 10 sec (except and
), than the operating conditions active before the Stop & Go operation
will be activated again. All reduced heater continue to work with the last
chosen heat setting. If no further button or is actiavted within 10 sec,
the heater turns off.
To Next Page
Loading...