It is recommend that you run a wash cycle with the
dishwasher empty and then remove the plug from the
socket, turn off the water supply and leave the door of
the appliance slightly open. This will help the door
seals to ast longer and prevent odours from forming
within the appliance.
If the appliance must be moved, try to keep it in the
vertical position. If absolutely necessary, it can be
positioned on its back.
One of the factors that cause odors to form in the
dishwasher is food that remains trapped in the seals.
Periodic cleaning with a damp sponge will prevent this
from occurring.
After every wash, turn off the water supply to the
appliance and le ave the door slightly open so that
moisture and odors are not trapped inside.
Before cleaning or performing maintenance, always
remove the plug from the socket.
To clean the exterior and rubber parts of the dishwasher,
do not use solvents or abrasive cleaning products.
Only use a cloth with warm soapy water.
To remove spots or stains from the surface of the
interior, use a cloth dampened with water with a little
vinegar, or a cleaning product made specifically for
dishwashers.
Af ter Eve ry Wash
Re move the Plug
No Solvents or Abrasi ve Cleaning
Moving the Appliance
Seal s
When it i s not in nee d for a long time
15
The installation of the pipes
and e lectrical equi pments
should be done by professionals.
Electrical Shock Hazard
Disconnect electrical power
before installing dishwasher.
Failure to do so can result in
death or electrical shock.
Th e inst allation posit ion of dishwasher should be near the existing inlet and d rain
ho ses an d pow er cor d.
One side of the cabinet sink should be chosen to fac ilitate the con nection of d rain
ho ses of the di shwasher.
Cleaning the Spray Arms
The spray arms can be easily removed for periodic cleaning
of the nozzles, to preve nt possible clogging. Wa sh them
under running water and carefully replace them in their seats,
checking that their rotary move ment is in no way impeded.
Grasp the middle of the spray arm, pull it upwards to remove
it. Wash the arms under a jet of running water and return them
carefully to their seat. After reassembly, check that the spray
arms turn freely. Otherwise, check that they have been
installed correctly.
To Next Page
Loading...