18
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be nece ssary to drain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink.
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water drain hose is not kinked or squashed.
If you need a drain hose extension, observe to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Water Outlet
Extension Hose
How to Drain Excess Water From Hoses
The foll owing things shoul d be ch ecked befor e starting the dishw asher.
1
The dish washer is le vel and fixed properly
2
The inle t valve is open
4
The wire s are t ightly connected
5
The pow er is switche d on
6
The inle t and drain hoses a re knotted
7
Al l packi ng materials and printing s should be taken out from the dishwasher
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
3
Inlet
hose connections are fully tightened an d not leaking
To Next Page
Loading...