EasyManuals Logo

VOX electronics LC-T8 User Manual

VOX electronics LC-T8
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
For each wash cycle.
Compartment
For programs with pre-wash only.
(Follow the user instructions)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Turn on the water tap and press the button. The machine will start working
after about 10 seconds.
Runnin g the dishwasher
Start/Reset
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes ( about 15 m inutes) before unloading the d ishwasher to avoid
handling the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower b asket.
Changing the programme
Add forgotten dishe s in the
dishwasher.
Scrape off any large food particles. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
program button
Operation instruction
When the working cycle is finished, the buzzer of the dishwasher will sound 8 times, then stop.
Turn off the appliance using th e
Power
b utton.
Since the appliance is standing by, it will power off automaticly after 30 minutes
without any operation.
If the app liance is switched
off during a wash cycle.
Open the door care fully.
Hot steam may esc ape
when the door is opened!
If the appliance was switched off during a wash cycle, when switched
on again, please re-select the washing cycle and o perate the dishwasher
from the beginning) .
Switch on the appliance Pr ess the Power switch button to switch on the appliance, Open the door.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can only be modified if it has be en running for a shor t time. Otherwise the detergent
may have already been releas ed and the water already drained. If in this case, the detergent
dispenser must be refilled.
2.
3. Select a new program.
4. Restart the dishwasher.
Press the Start/Reset button, then press the program button more than 3 seconds to cancel the
running program.
With each wash cycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programm e
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Changing the programme
Add forgotten dishe s in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
If the app liance is switched
off during a wash cycle.
Open the door care fully.
Hot steam may esc ape
when the door is opened!
Switch on the appliance Pr ess the Power switch button to switch on the appliance, Open the door.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can only be modified if it has be en running for a short time. Otherwise the detergent
may have already been releas ed and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pause button ,then press the program button more than 3 seco nds to cancel the
running programme .
3. Select a new programme.
4. Restart the dishwasher.
1.Press the start/pause button to stop the machine.
2.Open the door.
3.Add the forgotten dishes.
4.Close the door, then press the start/pause button, the dishwasher will
start running again after 10 seconds.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VOX electronics LC-T8 and is the answer not in the manual?

VOX electronics LC-T8 Specifications

General IconGeneral
BrandVOX electronics
ModelLC-T8
CategoryDishwasher
LanguageEnglish