PART 1 – OVERVIEW
3
WIRELESS PASSWORD
It is STRONGLY suggested that you enable password protection for your Voyager Air 2 Plus. After launching the app (or web
browser client), navigate to the Settings screen, look for the “Password:” setting, press the “Enable” button, then enter a
password. The password needs to be 8 to 63 letters long, with no spaces or special characters. That password will then
be required to make a wireless connection to the drive.
If you have enabled a Wi-Fi password but do not remember it, you can follow these steps to reset the password:
1. Make sure the Voyager Air 2 Plus drive is turned on.
2. Turn the drive over and locate the small hole on the bottom (near the front).
3. Insert a paper clip into the hole, press and release. This will reset the Wi-Fi password.
Note: This reset will not impact anything stored on the drive. It only disables the wireless password setting.
To Next Page
Loading...
