Need help?Do you have a question about the VPG BHL Nobel AST 3 and is the answer not in the manual?
General| Brand | VPG |
|---|---|
| Model | BHL Nobel AST 3 |
| Category | Transmitter |
| Language | English |
Describes display and function key operation for AST 3P in normal Operating mode.
Details power supply requirements and recommendations for continuous operation.
Explains the instrument's start-up sequence and initial display in Operating mode.
Displays the actual measurement value, instrument address, and relay status.
Shows weight value, address, and 'Zero' key for temporary zeroing.
Displays weight value, address, and the actual analogue output signal.
Shows switching levels for supervising channels or level 0 if not used.
Displays the actual input signal from the transducer and relay status.
Displays the instrument serial number and installed programme name.
Step-by-step guide for performing a zero setting in set-up mode to save to memory.
Describes how to mount the module on a DIN rail or flat surface.
Details requirements for connecting cables, avoiding interference, and routing.
Explains transducer connection, handling, and notes on cable routing and termination.
Overview of parameter setup via deltaCOM or panel, and calibration methods.
Defines language, measurement unit, resolution, capacity, and signal type parameters.
Instructions on how to access the 'Quick set-up' menu from normal operation mode.
Explains how to initiate parameter display in 'Quick set-up'.
Guides on selecting and confirming the language setting.
Describes how to define the measurement unit for the instrument.
Explains how to set the number of decimals and resolution of the last digit.
Guides on setting the instrument capacity corresponding to full analogue output range.
Defines the signal type for the analogue output.
Explains how to select between Data sheet and Deadweight calibration types.
Sets a constant to convert weight to data sheet unit.
Defines the total number of support points for the load.
Enters the rated load for a transducer as per data sheet.
Sets the rated output (mV/V) for each transducer or fixed support.
Sets the weight value to zero for the unloaded scale.
Reads the total zero offset value for scale setup.
Exits the 'Quick set-up' menu to the main menu.
Explains how to save or cancel changes made during 'Quick set-up'.
Defines the known load for the lower calibration point.
Defines the known load for the higher calibration point.
Reads the transducer signal value for calibration point 1.
Reads the transducer signal value for calibration point 2.
Sets the weight value to zero for the unloaded scale.
Reads the total zero offset value for scale setup.
Exits the 'Quick set-up' menu to the main menu.
Explains how to save or cancel changes made during 'Quick set-up'.
To Next Page
