VR46 UP! - Charging Method 2

12
• Remove the battery to open the silicone charging port, connect the charger DC plug to the battery
charging port; connect the power cable to the charger, then connect the other port to the outlet (100
V-240 V; 50/60 Hz) and check that the charger indicator is switched on normally.
• Cover the charging port with the dust cap in case metal is likely to come into contact with the charging
port and cause a short circuit at the end of the charging port.
The device is usually delivered partially charged. However, we recommend
chargingitfor6to8hoursbeforeusingitforthersttime.
We also recommend charging it after each use and before storing it.
Do not allow the scooter to discharge completely as this may damage the
battery.
Charging method 2
IMPORTANT
porta di ricarica
interfaccia della
batteria