VR46 UP! - 2. Quick guide

04
2. Quick guide
• Beforeusingthescooterforthersttime,fullychargethebattery.
• Press the power button for a few seconds to start it.
• Check the tyre pressure (50PSI); if the scooter does not reach at least 60% of the declared Km or does
 notreachthemaximumspeedwithintherst3monthsofuse,itislikelythatthewheelshavedeated
again. In this case, restore the pressure as indicated.
• Placethescooteronaatsurface
• Place your hands on the handlebars. Step onto the footrest with one foot and use the other to give
yourself a gentle push and accelerate.
• After use, check the battery indicator. If the battery is out of power, recharge it before use. The electric
scooter is a device that requires periodic recharging.
• When the scooter begins to move, place both feet on the footrest and press the accelerator.
• To steer the scooter, tilt your body in the direction of travel when turning and slowly turn the handlebar.
• To stop the scooter, release the accelerator and press the electronic brake or lever on the left side of the
handlebar.
• Togetoff,stopthescootercompletelyrst.Tryingtogetoffamovingscootermayresultininjuries.
• To change the speed mode, press the function button (chapter 5).
• When riding at night or in dark places, press the power button once to turn on the lights, wear a
 reectivevest.
For your own safety, wear a helmet and knee pads to protect yourself against falls and injuries
while learning to ride the electric scooter.
The rider assumes all responsibility for any injury suffered when not wearing a helmet or other
protective gear.
The accelerator is activated once the speed of travel exceeds 3 km/h.
For safety reasons, the scooter is initially set up to avoid standing starts.
IMPORTANT