Handset overviewCharger installation
Battery installation and charging
Specifications are subject to change without notice.
© 2015 VTech Communications, Inc.
All rights reserved. 04/15. CM18045_QSG_V2.0
Document order number: 96-010502-020-100
DND (Do not disturb)
• In idle mode, press and hold to turn
the feature on. Press and hold again
to turn off.
/SPEAKER
• Press to turn on the handset
speakerphone. Press again to
resume normal handset use.
• The indicator is on when the
speakerphone is in use.
REDIAL/PAUSE
• Press to view the last 10 numbers
dialed.
MUTE/DELETE
• During a call, press to mute the
microphone.
• While predialing, press to delete
digits.
• While reviewing the directory entry,
press to delete an individual entry.
• While entering or editing a directory
entry, press to erase a digit or
character. Press and hold to erase
all digits or characters.
Charge light
• On when the handset is charging in
the charger.
Softkeys (2)
• Press to select a menu item
displayed above the key.
LINE 1/LINE 2/LINE 3/LINE 4
• Press to make a call on the desired
line.
• Press to answer a call.
• The indicator is on when the
telephone line is in use.
• The indicator flashes slowly when
the telephone line is on hold.
• The indicator flashes quickly when
there is an incoming call.
DIR
• Press to scroll up while in menus.
• Press to show directory entries when
the telephone is not in use.
MENU/SELECT
• Press to enter the menu.
• While in a menu, press to select an
item or save an entry or setting.
CID
• Press to scroll down while in menus.
• Press to show the caller ID history
when the telephone is not in use.
INT
• Press to make an intercom call when
in idle.
• The indicator is on when the handset
is on an intercom call.
• The indicator flashes showly when
an intercom call is on hold.
• The indicator flashes quickly when
there is an incoming intercom call.
OFF/CANCEL
• While using menus, press to return
to idle mode.
• During a call, press to hang up.
-/VOLUME/+
• During a call, press to adjust the
listening volume.
• Press to adjust the ringer volume
when in idle mode.
PAGE
• Press to begin a one-to-one or one-
to-group broadcast.
Plug the power
adapter into an
electrical outlet not
controlled by a wall
switch.
1
2
3
GP1250
The CHARGE
light turns on.
GP1250
Add and register a handset
You can add CM18045 handsets to the CM18445
console at any time, each new handset must be
registered with the console before use.
The handsets are assigned with available
extension numbers starting from 1 in ascending
order (1 to 9). You can register a maximum of
nine devices to the console.
Register the handset to the console
Start registration when the handset shows
1) Press MENU on Console ->Registration
->Register Ext. 2) Press # on this extension to
register.
1. On the console, press MENU/SELECT.
2. Press DIR or CID to scroll to Registration,
then press MENU/SELECT or /SKIP.
3. Press MENU/SELECT or /SKIP to
choose Register ext. The console shows
Registering....
4. On the handset, press #. The handset shows
Registering....
5. You hear a beep sound when the registration
process is successful. The handset shows
Handset X registered. (X represents the
extension number, ranged from 1 to 9). It takes
up to 60 seconds to complete the registration
process.
6. Press a line key (LINE 1-LINE 4). If you hear a
dial tone, the registration was successful.
NOTE: If the registration is not successful, the console
returns to the previous screen. To reset the handset,
remove the handset from the charger. Wait for about two
minutes, then try the registration process again.
To Previous Page
Loading...
Need help?
General
