Console overview
LINE 1-LINE 4 keys
Press to make or answer a call on the desired line.
The indicator turns on when the telephone line is in use.
The indicator flashes slowly when the telephone line is
on hold.
The indicator flashes quickly when there is an incoming
call or a transfer call.
•
•
•
•
HOLD
Press to place an outside call or
intercom call on hold.
•
TRANSFER
Press to transfer a call to an
extension.
During message playback, press
to transfer the message to an
extension.
•
•
CONFERENCE
Press to add another extension or
outside line to an existing call.
•
FLASH
During a call, press to answer an
incoming call when you receive a
call waiting alert.
•
AUTO REDIAL
Press to view the last 10
numbers dialed.
•
SPEAKER
Press to turn on the speakerphone.
Press again to turn it off.
The indicator turns on when the
speakerphone is on.
•
•
MIC
HEADSET
When a corded headset is connected
to the console, press to make, answer
or hang up a call.
The indicator turns on when the
corded headset is in use.
•
•
+
/VOL/
-
During a call, press to adjust the
listening volume.
During message playback, press to
adjust the playback volume.
Press to adjust the ringer volume
when in idle mode.
•
•
•
INTERCOM
When in idle mode, press to initiate an
intercom call.
The indicator turns on when the
console is on an intercom call.
The indicator flashes slowly when the
console is holding an intercom call.
The indicator flashes quickly when
there is an incoming intercom call.
•
•
•
•
MUTE
During a call, press to mute the
microphone.
The indicator turns on when the
microphone is muted.
•
•
DND (do not disturb)
Press to turn the feature on. Press
again to turn off.
The indicator turns on when the do
not disturb function is on.
•
•
PAGE
Press to begin a one-to-one or one-to-
group broadcast.
The indicator turns on when a one-
to-one or one-to-group broadcast is
established.
•
•
Navigation keys
While in menus, press or to scroll
through the menus. Press /SKIP to enter
the highlighted item or save changes, or
press /REPEAT to return to the previous
menu.
While entering names or numbers, press
/REPEAT or /SKIP to move the cursor
to the left or right.
While playing back messages, press
/REPEAT to repeat the message, or
press /SKIP to skip to the next message.
•
•
•
MAIL BOX
When in idle mode, press to enter
the general mailbox menu.
MESSAGE WAITING
indicator
Turns on when there are new
messages in the general
mailbox.
•
CALL HISTORY
Press to view caller ID
information.
•
DIRECTORY
Press to view directory
information.
•
DELETE
While playing a message, press
to delete the message.
While reviewing the call history,
press to delete an individual
entry.
While predialing, press to delete
digits.
•
•
•
CANCEL
While in a menu, press to cancel
an operation and exit the menu
display.
•
MENU/SELECT
Press to enter the menu.
While in the menu, press to
select an item or save an entry
or setting.
•
•
Speed dial keys
Press to dial the desired speed
dial number.
•
LOWER
When assigning or dialing a speed
dial number, press to switch to
the lower location (the second 16
locations) of a speed dial key.
•
Console installation
Option 1: Four single-line jacks
Option 2: Two 2-line jacks
A
B
C
D
D
Low tabletop position
B
High tabletop position
D
B
One end of the coiled telephone line cord has
already been plugged into the handset. Make
sure it is plugged in firmly. Plug the other end
of the coiled handset cord into the left side of
the console.
Plug the telephone line cords into the
telephone line jacks of the console.
Plug the other end of the telephone line cords
into the telephone wall jacks.
Insert the connector of the power adapter to
the power jack on the back of the console.
Connect the plug head of the power adapter to a
power outlet that is not controlled by a wall switch.
1.
2.
3.
4.
5.
5
4
3
2
1
Line 1
Line 3Line 2 Line 4
Line 1/2
Line 3/4
5
4
3
2
1
1. Install the backup batteries.
To maintain normal system operation in the event
of a power failure, please purchase and install
four AA alkaline batteries to this console before
use. If power fails with working batteries installed,
all functions work properly except for the display
illumination.
2. Install the mounting bracket for tabletop use.
Insert the fixed tabs of the mounting bracket into
slots
A
and
B
. Press the flexible tabs into slots
C
and
D
until they click into place.
3. Connect the coiled handset, telephone line
cords and power cord.
To Previous Page
Loading...
