4
4
4
INSTRUCTIONS
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
Note: This toy phone has reduced volume to adhere to
safety regulations for close-to-the-ear toys.
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
back of the unit. Use a screwdriver
to loosen the screw and then open
the battery cover.
3. If used batteries are present,
remove these batteries from the
unit by pulling up on one end of
each battery.
4. Install 3 new AAA (AM-4/LR03) batteries following the
diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
To Next Page
Loading...
