VTech Go! Go! Smart Wheels Fast & Friendly Garage - INSTRUCTIONS; Battery Removal And Installation; IMPORTANT: BATTERY INFORMATION

7
INSTRUCTIONS
Battery Removal And Installation
1. Make sure the unit is turned OFF.
2. Find the battery cover located on the
bottom of the Speedy Race Car, use
a screwdriver to loosen the screw
and then open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
MPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommended
are to be used.