6
INSTRUCTIONS
Battery Removal And Installation
1. Make sure the unit is turned OFF.
2. Find the battery cover located on
the bottom of the Fire Truck, use a
screwdriver to loosen the screw and
then open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
MPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended are
to be used.
• Do not short-circuit the supply terminals.
To Next Page
Loading...
