VTech Go! Go! Smart Wheels Rescue Tower Firehouse - Assembly Instructions; Assemble gates, gate floor and wall components

9
ASSEMBLY INSTRUCTIONS
1. Assemble gates, gate floor and wall components by following the
steps below:
A. Snap the two Gate fronts (E) to the Gate floor(I). Insert the side
with a 1 on the back on the left of the Gate floor (I) and the side with
a 2 on the back on the right of the Gate floor (I) (see below). Then
insert the Gate in the two grooves in the base as shown.
B. Set the Gate top (H) on the Gate fronts (see below). Attach
the Back wall (G) using tabs on the Gate floor and Gate top. You
will hear a clicking sound.
With the Go! Go! Smart Wheels Rescue Tower Firehouse, safety
comes first. To ensure your child’s safety, adult assembly is required.
1
2