VTech Switch & Go Dinos Dino Launcher 2-in-1 User Manual

5
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom of the unit, use a
screwdriver to loosen the screw, and then open the battery cover.
3. Remove the old battery by
pulling up on one end of the
battery.
4. Install 1 new AAA (LR03/
AM-4) battery following the
diagram inside the battery
box. (For best performance,
alkaline batteries or fully Ni-MH
charged rechargeable batteries
are recommended).
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

VTech Switch & Go Dinos Dino Launcher 2-in-1 Specifications

General

Product Name	VTech Switch & Go Dinos Dino Launcher 2-in-1
Category	Toy
Batteries Required	Yes
Sound Effects	Yes
Manufacturer	VTech
Country of Origin	China
Recommended Age	4 years and up
Features	Transforms from dinosaur to vehicle