11
Wall mounting the charger
The charger is ready for tabletop use. If you want to mount the charger on a wall,
use two 10 mm (3/8 inch) screws and wall anchors to hold the charger in place.
Screws and wall anchors are not provided, but are available for purchase in many
hardware or consumer electronics retailers. You might need a professional to install
the charger.
To mount the charger on the wall:
1. Use a pencil to mark the desired positions of the two holes on the wall. Make
sure the space between the two holes is 30 mm (1 3/16 inches). Drill two holes
in the wall according to the marks.
2. If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud,
insert the wall anchors into the holes and tap gently
on the ends with a hammer until the wall anchors
are ush with the wall.
3. Insert the screws into the holes and tighten them
until only 6 mm (1/4 inch) of the screws are
exposed.
4. Align the holes at the back of the charger with the
screws on the wall and slide the charger down until
it locks into place.
Screw spacing 30 mm
(1 3/16 inches)
To Next Page
Loading...
Need help?
General
