To Next PageTo Next PageWhy my VWR International ISOLATOR 180 Petri Laboratory Equipment unit does not start?
Your VWR International Laboratory Equipment unit might not start due to several reasons. The battery could be low, in which case you should recharge it. Alternatively, the battery charger might not be working, so check it and replace if necessary (Cat. No. 710-0993). Finally, the battery could be too old, requiring a replacement.
What to do if the battery of VWR International ISOLATOR 180 Petri discharges quickly?
If the battery of your VWR International Laboratory Equipment discharges quickly, it could be due to a few reasons. The battery may be low and needs recharging. The battery charger might be faulty and require checking or replacement (Cat. No. 710-0993). Also, the battery could be too old and needs replacing.
What to do if VWR International ISOLATOR 180 Petri Laboratory Equipment shows 'CAL EXPIRED' message?
If your VWR International Laboratory Equipment displays a 'CAL EXPIRED' message, the instrument needs to be calibrated. Send the instrument to VWR International or an authorized dealer.
Why is microbiological media dehydrated after sampling with VWR International ISOLATOR 180 Petri?
If microbiological media is dehydrated after sampling with your VWR International Laboratory Equipment, it could be due to the media being corrupted. Check the expiration date of the media and confirm that the agar was not dehydrated before sampling. Another cause could be that the sampling time is too long; try shortening it.
What to do if the infrared remote switch doesn’t switch on VWR International ISOLATOR 180 Petri?
If the infrared remote switch isn’t turning on your VWR International Laboratory Equipment, the remote control battery is likely low. Replace the infrared remote battery.
General| Brand | VWR International |
|---|---|
| Model | ISOLATOR 180 Petri |
| Category | Laboratory Equipment |
| Language | English |
Describes the fundamental operating principle of the SAS air sampler for microbiological analysis.
Provides concise steps for operating the SAS Isolator, including startup and mode selection.
