Bluetooth Pairing
1. When you turn on the speaker, it will automatically enter pairing
mode and the LED indicator will start to flash blue rapidly
2. Enable Bluetooth on your phone or other compatible device and
select "W-KING D9-l "
3. When SUCCeSSfUIIypaired, the LED indicator will stay solid blue
Notes
To reset the speaker (to clear the pairing list or any program
errors), use a straightened paper clip to carefully short-press the reset
hole at the rear of the speaker
The speaker will automatically shut down after 10 minutes in
pairing mode if no devices are paired
If your paired device is switched off or manually disconnected,
the speaker will enter pairing mode and automatically shut down
after 10 minutes
If the speaker or connected device exceeds the operating range,
the speaker will disconnect. The connection to the last SUCCeSSfUIIy
connected device will be re-established once you re-enter wireless
range within 10 minutes. To connect to other devices, please repeat
the previous "Pairing" steps
Reset Speaker
Use a straightened paper clip to press the reset hole at the rear of
the speaker
Play Audio via Audio Input Connection
1. Connect the speaker to your PC, laptop, or other device with
audio OUtPUt port using the included 3.5mm audio cable
04
To Next Page
Loading...