Pairing
l. When you turn on the speaker, the speaker will automatically enter
pairing mode and the LED indicator will start to flash blue rapidly
2. Active the pairing function on your phone or other compatible device
and select "W-KING X 10"
3. If a code or pin is required for pairing, please enter "0000"
4. When successfully paired, the LED indicator will stay blue
Notes
To reset the speaker (to clear the pairing list or any program errors),
use a straightened paper clip or a toothpick to carefully short-press the
reset hole
The speaker will automatically shut down after 10 minutes in pairing
mode if no devices are paired
If your paired device is switched off or manually disconnected, the
speaker will enter pairing mode and automatically shut down after 10
minutes
If the speaker or connected device exceeds the operating range,
the speaker will disconnect. The connection to the last successfully
connected device be re-established once re—enter wireless
range within 10 minutes. To connect to other devices, please repeat the
previous "Pairing" steps
Playing Audio via Audio Input Connection
I . Connect the XIO to your PC, laptop, or other device with audio OUtPUt
port using the included 3.5mm audio cable
2. Long press the on/off button for 2-3 seconds to turn on, and the LED
indicator will light up solid green
TF Card Function
l. Insert a TF card into the TF card slot on XIO
2. Green LED confirms that the speaker has enter TF card mode
To Next Page
Loading...