To Next PageTo Next Page
Need help?Do you have a question about the Waeco ADLER /BARBOUR SERIES and is the answer not in the manual?
General| Brand | Waeco |
|---|---|
| Model | ADLER /BARBOUR SERIES |
| Category | Air Compressor |
| Language | English |
Instructions for securely mounting the main condensing unit horizontally.
Step-by-step guide for attaching the evaporator and routing refrigerant lines.
Properly sealing the tubing exit hole and handling refrigerant couplings.
Illustrates cutaway views of coupling halves at different connection stages and final seal formation.
Ensuring cleanliness and proper hand-threading of coupling halves.
Critical steps for final tightening and achieving correct torque for a permanent seal.
Instructions for mounting the thermostat and its installation procedure.
How to form and connect the sensing tube to the evaporator.
Steps for cutting the opening and mounting the digital control unit.
Guidance on placing the temperature sensing bulb for accurate readings.
Procedure for connecting the digital control's cable to the main unit.
Instructions for positioning and mounting the PowerPlate for optimal efficiency.
Steps for installing the tube set for the PowerPlate, including routing.
Details on connecting the small couplings to the PowerPlate and required torque.
Illustrates the recommended setup for the water cooling system's plumbing.
Shows correct and incorrect alignments for water pump and piping to prevent issues.
Diagnosing and correcting issues where the compressor and fan do not engage.
Diagnosing why the system runs but fails to cool the box adequately.
Troubleshooting cases where the evaporator frosts but cooling is insufficient.
Addressing system running constantly without any cooling effect.
