16
Setting the spray jet width (fig. 4)
Adjusting ring
Turn to the right = wider spray jet
Turn to the left = narrower spray jet
Note:
The adjusting ring does not fasten the air cap!
Setting the amount of material (fig. 5)
Set the amount of material by turning the material
adjustment knob.
Turn to the left = more material
Turn to the right = less material
Setting the amount of air (fig. 6)
The correct setting for the amount of air is decisive for the
atomization and formation of paint mist.
Setting the ascending feed pipe
Spraying object lying on floor (fig. 7)
Turn rotating lever clockwise as far as it will go.
Spraying object over head (fig. 8)
Turn rotating lever anti-clockwise as far as it will go.
Maximum
Minimum Minimum
g
To Next Page
Loading...
