WAGNER GM 4700AC - 5 Description; Components; Mode of Operation; Protective and Monitoring Equipment

17
5 DESCRIPTION
5.1 COMPONENTS
Designation
A
J
I
H
K
B
C
E
F
G
D
P_02379
A Suspension hook
B Shaping air regulator
C Spring cap
D Trigger
E Trigger locking device
F Air connection
G Fluid inlet
H Union nut with nozzle protection
I Nozzle / Air cap
J Gun housing
K Turning handle with lter housing
5.2 MODE OF OPERATION
If the trigger (D) is operated when the trigger locking device (E) is released, then the air
valve opens rst. Atomizing air ows through the air connection (F) to the air cap (I). The
product valve opens rst if approx. 1/2 of the trigger's path is covered. The quantity of air
for the atomization of the spray jet is preset via the external air automatic controller. The
spray pattern can be adjusted using the shaping air regulator (B).
5.3 PROTECTIVE AND MONITORING EQUIPMENT
The spray gun is secured with the locking device (E) (the locking device turned in the spraying
direction and fastened in the groove). The nozzle holder (H) has an anti-contact guard.
5.4 INCLUDED ITEMS
This AirCoat manual gun is available in two dierent versions. The choice of nozzle depends
on the application, therefore this component is not included in the standard scope of
delivery. A selection guide for spray gun accessories can be found in Chapter 13.
5.4.1 VERSION FOR APPLICATION UP TO 25 MPA; 250 BAR; 3625 PSI
Order no. Designation
1 2313585 GM 4700AC 25 MPa, NPSM1/4" product connection
1 2315700 GM 4700AC-H 35 MPa, NPSM1/4" product connection
(H = for processing heated product)
Please always order the nozzle separately.
5.4.2 STANDARD EQUIPMENT
Order no. Designation
1 2316429 CE Declaration of Conformity
1 2311729 Operating manual, in German
1 see Chapter 1.3 Operating manual in local language
1 394335 Spring cap 16 MPa; 160 bar; 2320 psi
For special versions the delivery note applies.
VERSION 06/2018
ORDER NUMBER DOC2311730