WAGNER GM 4700AC - Installation and Connection; Typical Aircoat Spraying System; Ventilation of the Spray Booth

20
6.4 INSTALLATION AND CONNECTION
The AirCoat manual gun GM 4700AC must be combined with various components to make
up a spraying system. The system shown in the gure is only one example of an AirCoat
spraying system. Your WAGNER distributor would be happy to assist you in creating a
spraying system solution that meets your individual needs.
You must familiarize yourself with the operating manuals and the safety regulations of all
additional system components before starting commissioning.
6.4.1 TYPICAL AIRCOAT SPRAYING SYSTEM
A
B
C
E
D
F
H
G
J
L
K
M
B_02380
N
I
Designation Designation
A Product pump H High pressure product hose
B Compressed air shut-o valve I High-pressure lter/product
pressure release
C Pressure regulator J Return line
D Air pressure regulator with air lter K Pump mounting trolley
E Grounding cable L Suction system
F Air hose, electrically conductive M Compressed air network
G AirCoat spray gun N Protective hose
6.4.2 VENTILATION OF THE SPRAY BOOTH
Operate the device in a spray booth approved for the working materials.
- or -
Operate the device on an appropriate spraying wall with the ventilation (extraction)
switched on.
Observe national and local regulations for the exhaust air speed.
VERSION 06/2018
ORDER NUMBER DOC2311730