WAGNER GM 4700AC - Replacing the Product Hose or Air Hose

30
8.2.4 REPLACING THE PRODUCT HOSE OR AIR HOSE
1. Flush and clean the spray gun in accordance with Chapter 8.1.2.
2. Relieve the pressure of the spray gun and device.
3. Secure the spray gun with the trigger locking device.
Product hose
4. Place the size A open-end wrench on the upper part of the product connection and
hold it in place.
5. Unscrew the product hose nut using the size B open-end wrench.
Air hose
4. Place the size D open-end wrench on the upper part of the air connection and hold
it in place.
5. Loosen the air hose's nut with a size C open-end wrench.
Assembly:
6. Screw on the product hose or air hose by hand and tighten with the two open-end
wrenches.
P_02386
B_02385
A
D
C
B
Note:
Do not unscrew the
lter connection.
The lter connection
should be replaced
in accordance with
Chapter 10.8.
Description Wrench A Wrench B Wrench C Wrench D
GM 4700AC with NPS1/4" lter
19 mm
0.75 inch
19 mm
0.75 inch
17 mm
0.67 inch
17 mm
0.67 inch
VERSION 06/2018
ORDER NUMBER DOC2311730