WAGNER GM 4700AC - 7 OPERATION; 7.1 Training the Operating Staff; 7.2 Safety Instructions

31
8.2.5 CHANGING OR CLEANING FILTER INSERT
1. Flush and clean the spray gun in accordance
with Chapter 8.1.2.
B_03649
64
83
66
67
open
2. Relieve the pressure of the spray gun and
device.
3. Secure the spray gun with the trigger
locking device.
4. Loosen the lter housing (67) manually with
turning handle (66) and unscrew it. When the
product hose together with lter housing
and lter insert has been exposed, push the
turning handle (66) back onto the upper lter
connection.
5. Pull the lter insert (64) out of the lter
housing (67).
6. Thoroughly clean all parts with ushing
agent.
Assembly:
7. Push the cleaned or new lter insert (64) with
opening downwards into the lter housing
(67).
8. Insert the lter housing (67) into the turning
handle, screw in manually with the turning
handle and tighten.
Procedure if connection is dicult to loosen:
Loosen lter housing (67) with wrench size
B open-end wrench, supporting the lter
connection with size A open-end wrench.
Wrench A Wrench B
13 mm
0.51 inch
17 mm
0.67 inch
B_02387
B
A
Note:
Do not unscrew the
lter connection.
The lter connection
should be replaced
in accordance with
Chapter 10.9.
VERSION 06/2018
ORDER NUMBER DOC2311730