39
10.9 REPLACING THE FILTER CONNECTION ONLY GM 4700AC
The following tools are required for carrying out the repair work on the spray gun described
below:
- Filter connection GM 4700AC, complete Order no. 2320114
- Open-end wrench, SW 13; 0.51 inch
- Loctite ® 638
- Hot-air gun
- Suitable oven for curing the adhesive
10.9.1 DISASSEMBLY
WARNING
Incompatibility of cleaning agent and working medium!
Risk of explosion and danger of poisoning by toxic gases.
Examine the compatibility of the cleaning agents and working media on the basis
of the safety data sheets.
WARNING
Hot gun housing!
Burns.
Wear protective gloves when dismounting the lter connection.
1. Dismount all movable and heat-sensitive (positions X) of the spray gun.
2. Use the air gun to heat the area around the hollow screw to approx. 150 °C; 302 °F.
3. Loosen the hollow screw with a size 13; 0.51 inch open-end wrench, then remove the
lter connection.
4. Thoroughly clean all re-usable parts with a suitable solvent.
B_02394
X
X
Heat to approx.
150 °C; 302 °F with
hot-air gun
VERSION 06/2018
ORDER NUMBER DOC2311730
To Next Page
Loading...
