40
10.9.2 ASSEMBLY
1. Apply the Loctite ® 638 to the thread and between the hollow screw and lter
connection.
2. Put the lter connection into the gun connection, align and tighten the hollow screw
with a tightening torque of 15 Nm; 11 lbft.
Exceeding the allowable torque will damage the lter connection.
WARNING
Hot gun housing!
Burns.
Wear protective gloves when dismounting the lter connection.
3. Harden the adhesion point in the housing in an oven at 40 °C; 104 °F for at least 30
minutes.
4. After cooling o, completely assemble the spray gun. In doing so, note the assembly
information in the spare part drawing in Chapter 14.2 of the operating manual.
5. Use a suitable medium to check the spray gun for leaks at 25 MPa; 250 bar; 3626 psi
or 16 MPa; 160 bar; 2320 psi.
B_04160
15 Nm;
11 lbft
Loctite 638
Order no. 2320114
Loctite 638
VERSION 06/2018
ORDER NUMBER DOC2311730
To Next Page
Loading...
