WAGNER GM 4700AC - Aircoat Pre-Atomizer Nozzles AC3000 Plus; Push-In Filter

45
13.5 AIRCOAT PREATOMIZER NOZZLES AC3000 PLUS
20° 30° 40° 50° 60°
08 208 308 408 508
200
200
0,008 (0,20) 0,22 (0,058)
10 210 310 410 510 610
150
0,010 (0,25) 0,32 (0,084)
12 212 312 412 512 612
100 100
0,012 (0,30) 0,44 (0,116)
14 214 314 414 514 614 0,014 (0,36) 0,60 (0,159)
16 216 316 416 516 616 0,016 (0,41) 0,76 (0,201)
18 218 318 418 518 618
60 50
0,018 (0,46) 0,92 (0,244)
20 320 420 620 0,020 (0,51) 0,11 (0,030)
22 422 622 0,022 (0,56) 0,14 (0,036)
100
(3,94)
145
(5,71)
195
(7,68)
250
(9,84)
300
(11,81)
B_05736
Article No. 321xxx
In order to determine the article number of a nozzle, please select the
number from the table and replace the three xxx.
Example: nozzle 410 -> article number 321410
Spray angle
Product lter (in mesh)
Edge lter Gun lter
Drilled hole Product ow*
Spray pattern width mm (inch)**
Size
inch (mm) l/min (gal/min)
* Tested with water and 100 bar pressure.
** Tested with 110 bar (1595 psi), 30 cm (11.81 inches) distance and lacquer 56DIN-4s.
13.6 PUSHIN FILTER
Order no. Filter sizes Mesh Use for nozzles
2315723 Push-in lter, red (10 pieces) 200 0.007" - 0.011"
B_02393
2315724 Push-in lter, blue (10 pieces) 150 0.011" - 0.013"
2315725 Push-in lter, yellow (10 pieces) 100 0.013" - 0.019"
2315726 Push-in lter, white (10 pieces) 50 0.019" - 0.023"
2315729 Push-in lter, green (10 pieces) 30 0.019" - 0.023"
VERSION 06/2018
ORDER NUMBER DOC2311730