WAGNER GM 4700AC - 15 Eu Declaration of Conformity

55
Order no. Designation
64
1 -- Filter insert, yellow (middle), 100 mesh per inch*
1 2315723 *Filter insert, red (ne), 200 mesh per inch, 10 pieces
1 2315724 *Filter insert, blue (middle), 150 mesh per inch, 10 pieces
1 2315725 *Filter insert, yellow (middle), 100 mesh per inch, 10 pieces
1 2315726 *Filter insert, white (coarse), 50 mesh per inch, 10 pieces
1 2315729 *Filter insert, green (coarse), 30 mesh per inch, 10 pieces
65 1 128389 Seal
66 1 2311491 Turning handle
67 1 2320016 Filter housing, complete
69 1 9998910 Instruction label "hot surfaces"
70 1 9998911 Protection label for 9998910
71 1 2352651 Spring cap 35 MPa; 350 bar; 5076 psi
72 1 -- Pressure spring for spring cap 35 MPa; 350 bar; 5076 psi
1 394941 Service set GM 4600/4700AC
= Wearing part
= Included in service set
= Not part of the standard equipment but available as a special accessory
15 EU DECLARATION OF CONFORMITY
Herewith we declare that the supplied version of:
GM 4700AC 25 MPa
GM 4700AC-H 25 MPa
complies with the following guidelines:
2006/42/EC
2014/34/EU
Applied standards, in particular:
EN ISO 12100:2010 EN 1127-1:2011
EN 1953:2013 EN ISO 80079-36:2016
EN ISO 13732-1:2008 EN ISO/IEC 80079-34:2011
EN14462:2015 --
Applied national technical standards and specications, in particular:
DGUV regulation 100-500 Chapter 2.29
DGUV regulation 100-500 Chapter 2.36
TRGS 727
Identication:
EU Declaration of Conformity
The EU Declaration of Conformity is enclosed with this product. If needed, further copies
can be ordered through your WAGNER dealer by specifying the product name and serial
number.
Order number: 2316429
VERSION 06/2018
ORDER NUMBER DOC2311730