WAGNER GM 4700AC - Mode of Operation; Protective and Monitoring Equipment; Scope of Delivery; Versions for Application up to 25 Mpa; 250 Bar; 3625 Psi

20
GM 4700AC
OPERATING MANUAL
VERSION 06/2014 ORDER NUMBER DOC2311730
If the trigger guard (D) is operated when the trigger guard locking device (E) is released,
then the air valve opens  rst. Atomizing air  ows through the air connection (F) to the
air cap (I). The material valve opens only when approx. 1/2 of the trigger guard's path is
covered. The quantity of air for the atomization of the jet spray is preset via the external air
automatic controller. The spray pattern can be adjusted using the shaping air regulator (B).
5.2 MODE OF OPERATION
Order No. Designation
1 2313585 GM 4700AC 25 MPa, NPSM1/4" product connection
1 2315700 GM 4700AC-H 25 MPa, NPSM1/4" product connection
(H = for processing heated material)
This AirCoat manual gun is available in two di erent versions. The choice of air cap and
nozzle depends on the application, therefore these components are not included in the
scope of delivery. A selection guide for gun accessories can be found in Chapter 13.
Order No. Designation
1 2316429 CE Declaration of Conformity
1 2311729 Operating manual, German
1 see Chapter 1.3 Operating manual in local language
1 394335 Spring cap 16 MPa; 160 bar; 2320 psi
For special versions the delivery note applies.
5.4.2 STANDARD EQUIPMENT
5.4 SCOPE OF DELIVERY
5.4.1 VERSIONS FOR APPLICATION UP TO 25 MPA; 250 BAR; 3625 PSI
The standard equipment for guns includes:
The spray gun is secured with the locking device (E) (the locking device turned in the
spraying direction and fastened in the groove).
5.3 PROTECTIVE AND MONITORING EQUIPMENT