37
GM 4700AC
OPERATING MANUAL
VERSION 06/2014 ORDER NUMBER DOC2311730
Note:
Methylene chloride is not recommended as an agent for ushing or cleaning the spray
gun or other system components.
1. Relieve the pressure on the spray gun and product pressure generator in
accordance with Chapter 7.3.3.
2. Secure the spray gun with the locking device.
3. Connect the solvent supply.
4. Dismount AirCoat nozzle and clean separately (see Chapter 7.3.4 and 7.3.5).
5. Raise the pressure of the rinsing agent supply up to a maximum of 4 MPa; 40 bar;
580 psi and thoroughly rinse the spray gun.
6. Relieve the pressure on the spray gun and product pressure generator.
7. Secure the spray gun with the locking device.
8. Clean the spray gun body with a cleaning agent recommended by the lacquer
manufacturer and dry with a cloth or blow gun.
DANGER
Incorrect maintenance/repair!
Danger to life and damage to the device.
Only a WAGNER service center or a suitably trained person may
carry out repairs and replace parts.
Only repair and replace parts that are listed in the "Spare Parts"
chapter and that are assigned to the device.
Before all work on the device and in the event of work
interruptions:
- Switch o the energy/compressed air supply.
- Relieve the pressure from the spray gun and device.
- Secure the spray gun to prevent actuation.
Observe the operating manual and service manuals at all times
when carrying out work.
To Next Page
Loading...
