WAGNER GM 4700AC - Replacing the Product Hose or Air Hose

41
GM 4700AC
P_02386
B_02385
A
D
C
B
OPERATING MANUAL
VERSION 06/2014 ORDER NUMBER DOC2311730
1. Flush and clean the gun as described in Chapter 8.1.3.
2. Relieve the pressure of gun and device.
3. Secure the gun with the locking device.
Product hose
4. Place the size A open-end wrench on the lower  ats of the product connection and
hold it in place.
5. Unscrew the product hose nut using the size B open-end wrench.
Air hose
4. Place the size D open-end wrench on the  ats of the air connection and hold it in
place.
5. Loosen the air hose's nut with a size C open-end wrench.
Assembly:
1. Screw on the product hose or air hose by hand and tighten with the two open-end
wrenches.
Note:
Do not unscrew the  lter
connection. The  lter
connection should be
replaced in accordance with
Chapter 10.8.
Description Wrench A Wrench B Wrench C Wrench D
Width across
 ats
Width across
 ats
Width across
 ats
Width across
 ats
GM 4700AC with NPS1/4"  lter
19 mm 19 mm 17 mm 17 mm
0.75 inch 0.75 inch 0.67 inch 0.67 inch
8.3 REPLACING THE PRODUCT HOSE OR AIR HOSE