WAGNER GM 4700AC - Page 61

61
GM 4700AC
OPERATING MANUAL
VERSION 06/2014 ORDER NUMBER DOC2311730
Activities Aid tools
4. Checking the switching sequence
- Attach the AC nozzle and air cap. Visual inspection
- Set the injection pressure to 100 bar; 10 MPa; 1450.40 psi, pull the
trigger guard slowly, note the switching sequence "switch on" and
"switch o ".
Switch on: atomizing air / shaping air on, product on
Switch o : product o , atomizing air / shaping air o
5. Flushing the gun
- Switch o the air and material supply, open  ushing valve, pull
trigger lever and  ush gun or blow out with air.
Flush the gun without the valve and air cap.
In doing so, you can remove the air connection hose.
- Close the  ushing valve; when almost no material is escaping any
longer, remove the product connection hose and blow the rest of the
test medium out of the gun using an air gun.