To Next Page

To Previous Page

English

Cleanup (continued)

5. Remove container from pump. Leave suction tube

submerged into the bucket of the appropriate cleaning

solution.

6. Hang the roller arm from the bucket.

7. Fully press and release the handle button to run the

appropriate cleaning solution through the hoses and

roller arm.

Note: Allow the pump to circulate the cleaning solution

for about 10 minutes. If desired, refill the bucket with new

cleaning solution and repeat for another 5 minutes.

8. While unit is self-cleaning, disassemble the roller

assembly*, and thoroughly clean the roller cover, core,

and cap by hand.

* Insert thumb to rst knuckle, pry and pull the cap from

the roller cover. Once the cap is removed, push the core

out the other end. DO NOT throw away the core and

cap.

9. Fully press and release the handle button to switch the

motor o.

Remove suction tube from solution and run motor until

all cleaning solution is purged from the unit. Turn the

switch OFF. Unplug power cord.

10. Press quick-release tabs and remove the roller arm from

the roller handle. Remove any remaining paint with the

appropriate cleaning solution and a damp cloth.

IMPORTANT: If you used mineral spirits to clean your

unit, you must repeat all the steps on this page using

warm, soapy water.

CLEANING

SOLUTION

WAGNER SideKick User Manual

Questions and Answers: