4.2 HIGH PRESSURE HOSE AND PRESSURE GAUGE
To check whether or not the hose is pressu-
rized, the provided pressure gauge has to be
secured to the high-pressure hose.
1. Screw the pressure gauge (11) to the hose connection (A)
or to the gun (B).
2. Screw the high pressure hose (9) onto the hose connec-
tion or the pressure gauge.
3. Screw the gun (10) or the material ball cock onto the high
pressure hose.
4. Tighten all union nuts on high pressure hose so that no
material can escape.
When unscrewing the high pressure hose,
hold rmly on the hose connection with a
22mm wrench.
4.3 HOPPER
1. Ensure that the sealing surfaces of the connections are
clean. Ensure that the red inlet (1) is inserted in the coat-
ing material inlet (4).
2. Screw the union nut (5) on the return pipe (6) onto the
connection (7).
3. Screw the upper hopper (8) onto the coating material in-
let (4).
11
A
B
11
1
4
5
6
7
8
9
10
To Next Page
Loading...
