WAGNER Super Finish 33 PLUS - Electrical System Indicators and Upgrades; Electric Console LED Indicators; Soft Start Controller Retrofitting

12
Super Finish 33 PLUS/PRO • Nespray Pro
3.8 INDICATORS AT THE ELECTRIC CONSOLE
POS DESCRIPTION
1 LED red (Indicator for voltage supply - lights up when there is voltage supply)
2 LED green (Indicator for “ready for operation” – lights up when there is voltage supply and the thermal fuse is closed
= means temperature of the motor is ok)
3 LED yellow (Indicator for contactor – lights up when contactors are xed and there is voltage supply for the motor)
RED
GREEN YELLOW
3.9 SOFT START CONTROLLER UPGRADE SERVICE KIT 2404531
GB
1. Lift the board to loosen screw (1).
2. Mount the soft start circuit (2).
Attention: Place the toothed washer
(3) under the lower screw for earthing
(tightening torque 5 Nm).
3. Wiring (4) according to the following wiring
diagrams (the complete wiring diagrams can
be found in the „Electrical Repair Instructions“
at the end of this service manual).
1
2
4
3
If required, the soft start controller
not included in the standard con-
guration of the SF33 can be retrot-
ted by the service department.