10
1. Ensure that the pasta cooker tank is full of water to the upper fill mark.
2. Check that the electrical supply is turned ‘On’ at the mains supply.
3. Select the ‘power’ level on the element control knob to either Simmer / Boil / or Rapid as required.
The ‘green’ power indicator will illuminate.
4. Rotate the thermostat knob to the desired temperature. The ‘amber’ heating indicator will illuminate
until the temperature is reached.
NOTE: It will take approximately 28 minutes to heat the water in the tank from 20°C to 100°C. (This
time has been calculated for the PC8140E Pasta Cooker that is fitted with the 10.5kW
element).
IMPORTANT:
THE USE OF ROCK SALT IS NOT PERMITTED IN THIS MACHINE .
NEVER add salt to cold water - always ensure that the water in the pasta cooker is
boiling before adding salt.
Clean the pan regularly after each use.
1. Rotate the element control knob to the ‘O’ position, to turn ‘Off’ the pasta cooker.
2. The ‘green’ power indicator and the ‘amber’ heating indicators will extinguish.
To Next Page
Loading...
Need help?
General