To Next Page

To Previous Page

Safety Instructions

SAFETY, CONTROL, AND INSTRUCTION DECALS

Safety, Control, and Instruction Decals are installed on the machine;

if any are missing, illegible, or damaged, a replacement should be ordered and installed before

putting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.

Location: Front Body, LH Side Above Mufer

Part Number: 8600-12

1. Warning – carbon monoxide (CO) poisoning

hazard.

• CO emitted by a running engine can be deadly.

• Do not operate indoors or in other enclosed

areas.

8600-12

Location: Instrument Panel

Part Number: 8823-6

Location: Front Body Adjacent to RH

Steering Lever

Part Number: 8600-34

1. Warning – read Operator’s Manual before oper-

ating the machine.

Warning – wear eye and ear protection when op-

erating the machine.

2. Warning – roll-over hazard

• Do not operate on slopes greater than 15

degrees.

3. Warning – thrown object hazard.

• Keep bystanders away from the machine

when operating.

4. Warning – entanglement hazard.

• Keep all guards in place while engine is run-

ning.

Location: Gearbox Cover

(Gear Drive Decks Only)

Part Number: 8600-9

1. Tighten blade nuts on gear driven decks to

60 lb·ft (81 N·m).

8600-9

60 lb·ft (81 N·m)

Walker T25i Operator's Manual

Other manuals for Walker T25i